Please fill out the form below and we will get back to you as soon as possible.
I am agree with terms of uses.

Cart List

  • No products
  • Sub Total



    LIFT UPS - 15 HP

    An Elevator UPS or Lift UPS is Basically a type an offine UPS which has three main parts, A Charger, Batteries and An Inverter. It takes Three Phase supply and Powers the Elevator while charging the Batteries at the same time. It acts as an effective Power backup solution for Elevators.

    POWERTEK Lift UPS is specially designed to run  electrical motors by handling high inrush current of the motors. It proves to be a helping hand during Grid absence by generating 1 Phase 2 wires output supply from its back-up system. Powertek  Lift UPS is embedded with Isolated boost charging technology which provides constant charging voltage & current when Grid is available. It also senses the Grid failure & starts automatically by utilizing the energy stored in the battery back-up system.   Lift UPS is capable of driving Lifts/Elevators.


    * Advance Operation Mode

    * Compatible with Generator

    * Pure Sinewave Output

    * Easy Installation

    * Long Run Battery

    * Compact size also avilable in wallmounting Cabinet

    * Complete Installation support by Industry experts

    * Improved charge for Low AH Batteries.

    Product name LIFT UPS
    Series ACE Series
    Model No. VX - 15
    Rating 15 HP
    Operating DC voltage 72V
    No. of Batteries 6
    No of Phase 1 Phase - 2 Wire P, N
    Voltage Range 165V - 270V AC
    Main low Recovery Range 10V
    Main High Recovery Range 5V
    Frequency Range 50 Hz +/- 3%
    Battery Charging Stages 3
    Switching Power Device Mosfet
    Control PWM
    Output voltage 230V AC +/- 2%
    Phase 1 Phase - 2 wire P, N
    Output Waveform Pure Sine Wave
    Frequency 50 Hz (Free running)
    Changeover Time UPS/ARD to Mains Three second
    Changeover Time Mains to UPS/ARD <10ms
    Rated Output Power Factor 0.8
    Switch UPS ON/OFF
    LED Indication Inverter ON, Batt. Low,/High, Overload, Mains Charging ON, Mains ON .
    Alarm Battery Low, Overload, Charger ON, Inverter ON
    Protection Overload, short Circuit Protection, over Voltage, Mains Surge and Transient  Protection (MOV Varistors), Reverse Polarity of Batt., Over Tempeature Protection Under Voltage and Over Voltage Protection.
    Operating Temp 0 - 50°C
    Operating Humidity (RH Value) < 95
    Protection Class IP 20
    Low Cut Off 10V/Batt. +/- 2%
    Battery Low Buzzer 10.5V/ Batt. +/- 2%
    Low Cut off Recovery 12V/ Batt. +/- 2%
    High Cut Off 15.5/Batt. +/- 2%
    High Cut off Recovery 15.0/Batt. +/- 2%
    Charging Current by Grid 1 to 3 +/- 2% (Selectable)
    Output @ No. Load 220 +/- 2% , 230 +/- 2%
    Output Freqency 50Hz +/- 2%
    Output @ Full Batt. to Low Batt. 220 +/- 2% , 230 +/- 2%
    Output Low Cut 165V
    Output High Cut 270V
    Output Low Retry 1 Time
    Output Short Circuit 5 Time
    UPS/ARD Backup Time 3 Minutes
    No Load Batter Current 2%
    Overload 3.6A/KVA
    Switching Element Mosfet
    Control Type Microcontroller
    Type of Charger Booster
    Efficiency 95%
    Battery Charging Stages 3 Stage Battery Charging to Keep Batteries Ready for Rescue
    Power Factor 0.8